LED Inline Controller

inline-controller-lg.jpg
inline-controller-lg.jpg

LED Inline Controller

12.00

This 2-channel unit controls up to 2 Amps of LEDs, giving you incredible control over their strobe pattern. Adjust the duration the LEDs are OFF and ON! Works with any 12v light!

Quantity:
Add To Cart

Instructions

CONNECTION:
There are two ends on the inline controller, a power source will connect to one end and your 12v lights to the other.
• The end marked "12-24V" is where you will connect your power source. Connect your power wires to the blue terminal, matching the black wire from your power source to the black wire on the blue terminal, and red to red.
• The end marked "LED" is where you connect your 12v LED Light. Connect the wires from your light to the blue terminal, matching the black wire from your light to the black wire on the blue terminal, and red to red.
The maximum load the controller will handle is 144w worth of 12v LED Lighting 

The inline controller is polarity sensitive. You must make sure all wire colors match when connecting the unit to avoid failure 

SETTINGS:
• To power ON quickly press the middle button ("SPEED"). 
• To power OFF hold down the middle button ("SPEED").

• To DIM lights press the "LIGHT" button once. Then, press "SPEED" to increase brightness or "LIGHT" to decrease brightness 

• To use a preset dynamic mode, press "MODE" to cycle through the five different presets. Press "SPEED" to adjust the speed of the presets. To exit the preset modes, press "LIGHT" once to enter back into the dimming function

Specifications

Maximum Load 144 watts
Input Voltage 12v DC
Length 10 in.
Width 0.5 in